2005 Buick Century BaseFACTORY OEM SERVICE PROCEDURE

Automatic Transmission Shift Lock Control Connector End Views

WARNING: This page is about a different car, the 2004 Buick Regal, 2004 Buick Century, 2003 Buick Regal, and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
A/T Shift Lock Control Solenoid Connector End Views (Century)

GM280768Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12052832
  • 2-Way F Metri-Pack 150 Series (BLK)
Pin Wire Color Circuit No. Function
A DK GRN/ WHT 1135 A/T Shift Lock Control Solenoid Supply Voltage
B BLK 150 Ground
A/T Shift Lock Control Switch Connector End Views (Regal)

GM40422Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12064762
  • 6-Way F Metri-Pack 150 Series (GRY)
Pin Wire Color Circuit No. Function
A ORN/BLK 434 Neutral Safety Switch Signal
B PNK 1439 Ignition 1 Voltage
C LT BLU 1134 Ignition Lock Cylinder Control Actuator Signal
D - - Not Used
E DK GRN/WHT 1135 A/T Shift Lock Control Solenoid Supply Voltage
F PPL 1600 Ignition 0 Voltage
Brake to Shift Relay Connector End Views

GM309518Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12129715
  • 6-Way F Metri-Pack 280 Series Flexlock (MD GRY)
Pin Wire Color Circuit No. Function
A1 PNK 1439 Ignition 1 Voltage
PNK 1439 Ignition 1 Voltage (Regal)
A2 ORN/BLK 434 Neutral Safety Switch Signal
B1-B2 - - Not Used
C1 BLK 1550 Ground
C2 TAN/WHT 816 A/T Shift Lock Solenoid Supply Voltage
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.