2005 Buick Century BaseFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Regal and 2004 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Record the 11-digit electronic serial number (ESN) and the 10-digit station identification (STID) number from the label on the new VCIM.
  2. Position the communication interface module to the bracket (2).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bolts (1) to the communication interface module.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    4. Fig 1: Communication Interface Module & Bolts
    GM1364564Courtesy of GENERAL MOTORS CORP.
  4. Connect the GPS antenna cable to the module.
  5. Connect the electrical connectors to the module.
    6. Fig 2: Communication Interface Module Electrical Connectors
    GM813766Courtesy of GENERAL MOTORS CORP.
  6. Connect the cellular antenna cable to the module.
    7. IMPORTANT: After replacing the communication interface module, you must reconfigure the OnStar® system. Failure to reconfigure the system will result in an additional customer visit for repair.
  7. Reconfigure the OnStar® system. Refer to OnStar Reconfiguration .
  8. Position the assembly to the studs.
  9. Install the bracket nuts to the communication interface module.

    Tighten:  Tighten the nuts to 4 N.m (35 lb in).

    10. Fig 3: Communication Interface Module Bracket Nuts
    GM769963Courtesy of GENERAL MOTORS CORP.
  10. Install the communication interface module cover.
    11. Fig 4: Communication Interface Module Cover
    GM769971Courtesy of GENERAL MOTORS CORP.
  11. Close the rear compartment.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.