Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Buick Century BaseFACTORY OEM SERVICE PROCEDURE
Control Module References
Control Module References
| Control Module | Schematic | Repair Instruction | Programming and Setup |
|---|---|---|---|
|
|||
| Audio Amplifier | Radio/Audio System Schematics in Entertainment | Amplifier Replacement in Entertainment | This device requires no programming or setup |
| Body Control Module | Body Control System Schematics | Body Control Module Replacement | Body Control Module Programming and Setup |
| Communication Interface Module (OnStar®) | OnStar Schematics in Cellular Communication | Communication Interface Module Replacement in Cellular Communication | Communication Interface Module (OnStar) Programming and Setup |
| Cruise Control Module | Cruise Control Schematics in Cruise Control | Cruise Control Module Replacement in Cruise Control | This device requires no programming or setup |
| Electronic Brake Control Module (ABS) | ABS Schematics in Antilock Brake System | Electronic Brake Control Module Replacement in Antilock Brake System | This device requires no programming or setup |
| HVAC Control Module | HVAC Schematics in HVAC Systems - Automatic | HVAC Control Module Replacement in HVAC Systems - Automatic | Re-Calibrating Actuators in HVAC Systems - Manual after HVAC control module or actuator replacement |
| Ignition Control Module | Engine Controls Schematics in Engine Controls - 3.1L | Ignition Control Module Replacement in Engine Controls - 3.1L | This device requires no programming or setup |
| Inflatable Restraint Sensing and Diagnostic Module (Supplemental Inflatable Restraint) | SIR Schematics in SIR | Inflatable Restraint Sensing and Diagnostic Module Replacement in SIR | Inflatable Restraint Sensing and Diagnostic Module Programming and Setup |
| Instrument Panel Cluster | Instrument Cluster Schematics in Instrument Panel, Gages, and Console | Instrument Panel Cluster (IPC) Replacement in Instrument Panel, Gages, and Console | This device requires no programming or setup |
| Powertrain Control Module | Engine Controls Schematics in Engine Controls - 3.1L | Powertrain Control Module (PCM) Replacement in Engine Controls - 3.1L | Powertrain Control Module Programming and Setup (3100 (LG8)) |
| Radio | Radio/Audio System Schematics in Entertainment | Radio Replacement in Entertainment | Radio Setup in Entertainment after radio replacement |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
