Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2005ALLURE (CANADA) V6-3.8LREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY RECEIVERSERVICE AND REPAIR
2005 Buick Allure (CANADA) V6-3.8L
Keyless Entry Receiver: Service and Repair
2005 Buick Allure (CANADA) V6-3.8LSECTION Service and Repair
REMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENT
REMOVAL PROCEDURE
1. Remove the rear window shelf trim panel.
2. Disengage the outboard receiver retainers from the rear shelf.
3. Lift the receiver from the rear window shelf trim panel and disconnect the electrical connector.
4. Remove the receiver.
INSTALLATION PROCEDURE
1. Connect the electrical connector to the receiver.
2. Install the receiver by positioning the inboard retainer to the slot in the rear window shelf trim panel. Press the outboard retainers into the rear window shelf trim panel openings.
3. Install the rear window shelf trim panel.
4. If a new remote control door lock receiver is being installed, program the transmitters. Refer to Transmitter Programming. Programming and Relearning
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.