2005 Buick Allure (CANADA) V6-3.6LFACTORY OEM SERVICE PROCEDURE

Coolant Temperature Sensor/Switch (For Computer): Service and Repair



ENGINE COOLANT TEMPERATURE (ECT) SENSOR REPLACEMENT

REMOVAL PROCEDURE

CAUTION: Allow sufficient time for the engine to cool before removing the ECT sensor. A hot engine may cause an excessive coolant loss or a personal injury.

1. Turn the ignition OFF.
2. Partially drain the cooling system. Refer to Draining and Filling Cooling System.

Factory service manual diagram



3. Remove the coolant temperature sensor electrical connector.

Factory service manual diagram



4. Remove the coolant temperature sensor.

INSTALLATION PROCEDURE

Factory service manual diagram



1. Install the coolant temperature sensor.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the sensor to 22 N.m (16 lb ft).

Factory service manual diagram



2. Install the coolant temperature sensor electrical connector.
3. Inspect and fill the cooling system as necessary.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.