2004 Buick Century BaseFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Grounds

GROUNDS LOCATION

Component Location
G100 Right side of engine compartment, at base of battery. See Figure .
G101 Front left side of radiator support. See Figure .
G111 (3.1L VIN J) Lower left front of engine, on transaxle stud, left of starter. See Figure .
G111 (3.8L VIN K) Right front of engine, on ignition control module bracket. See Figure .
G111 (3.8L VIN 1) Right front of engine, on ignition control module bracket. See Figure .
G113 (3.1L VIN J) Lower right front of engine, on transaxle stud, left of starter. See Figure .
G113 (3.8L VIN K) Lower right front of engine, on transaxle stud, left of starter. See Figure .
G113 (3.8L VIN 1) Lower right front of engine, on transaxle stud, left of starter. See Figure .
G171 Left side of engine compartment, below master cylinder. See Figure .
G200 Behind right side of dash compartment. See Figure .
G201 Below dash, left side of steering column.
G203 Below dash, right side of steering column. See Figure .
G301 Inside left door sill, forward of left front seat. See Figure .
G401 Inside rear compartment, below left side of rear window trim panel. See Figure .
G402 Inside rear compartment, below right side of rear window trim panel.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.