Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Buick Century CustomFACTORY OEM SERVICE PROCEDURE
Traction Control Switch (Intrigue): Removal
- Raise the front floor center console armrest.
- Remove the 2 retainers that attach the front floor console trim plate to the front floor console. See Figure .
- Open the front floor console cupholder.
- Gently pull up on the front floor console trim plate to gain access to the traction control switch.
- Disconnect the traction control switch wiring harness connector from the traction control switch.
- Remove the traction control switch from the front floor console trim plate. To avoid damage to the front floor console trim plate, use a small flat-bladed tool on the back side of the traction control switch to release the retaining clips. See Figure .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.