2000 Buick Regal LSFACTORY OEM SERVICE PROCEDURE

Preliminary Inspection

Verify customer complaint by operating suspected malfunctioning system. Visually inspect for obvious signs of mechanical and electrical damage. Repair as necessary. Inspect for faulty fuses, loose or corroded connections, damaged wiring harnesses and/or switches. Repair as necessary. Check for a broken or partially broken wire inside insulation, which could cause system malfunction but prove good in a continuity/voltage check with system disconnected. Repair as necessary. Ensure any aftermarket electronic equipment is properly installed. Repair as necessary. If no problem is found, perform BCM diagnostic circuit check. See BODY CONTROL MODULE (BCM) DIAGNOSTIC SYSTEM CHECKΒ  under SELF-DIAGNOSTIC SYSTEM.

Fig 1: Locating Body Control Module (BCM) & BCM Harness Connectors
G00015135Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.