2000 Buick Century CustomFACTORY OEM SERVICE PROCEDURE

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the upper trim panel from the instrument panel (IP). Refer to TRIM PANEL REPLACEMENT - INSTRUMENT PANEL (IP) Upper .
  2. Release the door lock receiver from the IP by releasing the retainer tabs.
  3. Disconnect the electrical connector.
  4. Remove the door lock receiver.
    Fig 1: Remove IP Upper Trim Panel, Door Lock Receiver & Electrical Connector
    G01833123Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.