Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Password Learn Procedure For Anti-Theft System
1999 Buick Regal LSSECTION Password Learn Procedure For Anti-Theft System
- Password learn procedure must be performed if Powertrain Control Module (PCM), Pass-Key(R) III module, ignition lock cylinder, steering column assembly or ignition key are replaced. A password is communicated between Pass-Key(R) III module and PCM to provide engine operation. If PCM is replaced, the PCM must learn the password from the Pass-Key(R) III module.
- Insert a valid mechanical coded unlearned ignition key in the ignition switch. Place ignition switch in the RUN position. The SECURITY indicator light will come on for 10 minutes for the length of the auto learn timer. SECURITY indicator light is located on instrument panel, just below the fuel gauge.
- When auto learn timer expires and SECURITY indicator light goes off, place ignition switch in OFF position. Remove ignition key from ignition. Wait 10 seconds.
- Repeat steps 2) and 3) two more times, for a total of 30 minutes. Insert the newly learned ignition key in ignition switch.
- Place ignition switch in RUN position. The SECURITY indicator light should remain off to indicate the ignition key was learned. If security indicator does not remain off, repeat procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.