1999 Buick Century CustomFACTORY OEM SERVICE PROCEDURE

Window Switch: Installation

  1. Install the switches to the mounting plate. See Figure.
  2. Connect the electrical connectors.
  3. Snap the switch and mounting plate into the trim panel. See Fig 1.
Fig 1: Front Door Window Switch From Door Panel
G00159779Courtesy of GENERAL MOTORS CORP.


  1. Install the switch tabs into the bezel slots. See Fig 2.
  2. Press down on the tabs in order to secure the switch. See Fig 1.
  3. Connect the electrical connector to the window switch.
  4. Align the bezel to the door trim panel opening and press into place to secure.
Fig 1: Rear Door Power Window Switch
G00159781Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.