1999 Buick Century CustomFACTORY OEM SERVICE PROCEDURE

Method 2 (Scan Tool Required)

In the event that a transmitter is lost, program the old and the new transmitters into the memory of the remote control door lock receiver. Up to 4 transmitters may be programmed.

NOTE: Once entering this procedure, programing/diagnostic mode, the first transmitter erases all previous transmitters. You must program all transmitters. Program one vehicle at a time. One transmitter could be programmed into other vehicles that are also in program mode in close proximity.

The following procedure describes how to program the remote control door lock transmitter to the remote control door lock receiver using the Tech 2Ā® or an equivalent scan tool. Perform the following steps:

  1. Connect the scan tool to the following components; an applicable power source and the vehicle Data Link Connector (DLC).
  2. Turn the ignition on.
  3. At the application menu screen, select F0 (body control module).
  4. At the body control module screen, select F2 (special function).
  5. At the special function screen, select F3 (program key fobs).
  6. Follow the directions on the scan tool display in order to program to transmitters.
  7. Press exit repeatedly until you view the application menu screen.
  8. Disconnect the scan tool from the accessory power port and the vehicle DLC.
  9. Validate that all the transmitters that were programmed operate properly. See REMOTE KEYLESS ENTRY SYSTEMĀ  under DESCRIPTION & OPERATION.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.