Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transmitter Synchronization
Loss of transmitter synchronization will occur when the following conditions are present:
- If the transmitter is activated more than 256 times while the transmitter is out of range of the remote control door lock receiver.
- After the transmitter battery replacement, if the transmitter is immediately activated more than 16 times while times while the transmitter is out of range of the remote control door lock receiver.
In order to resynthesized the transmitter, press and hold the transmitter lock and unlock buttons simultaneously for at least 7 seconds, or until the following condition is present, the horn sounds 3 times. Perform the resychronization procedure if the following conditions exist:
- The batteries on the keyless entry transmitter have been replaced.
- A keyless entry transmitter is malfunctioning.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
