Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Buick Century CustomFACTORY OEM SERVICE PROCEDURE
Method 2 (Scan Tool)
The following procedure describes how to customize the remote unlock verification feature using the Tech 2®. This procedure may also be accomplished by using an equivalent scan tool.
- Connect the scan tool to an applicable power source and the Data Link Connector (DLC).
- Turn the ignition switch to the on position.
- At the application menu screen, select the F5 (personalization).
- At the personalization main menu screen, select the F0 (set options).
- At the set options main menu screen, select F2 (verify unlock mode).
- After reading the setting options screen, select done.
- At the set options screen, use the up and down arrow buttons to move the highlighter to the desired option (mode).
- Select the active options, then select the save options.
- Press the exit repeatedly until the application menu screen is viewed.
- Disconnect the scan tool from the accessory power port and the vehicle DLC.
- Validate that the option (mode) selected was activated by operating that system.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
