Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Buick Century CustomFACTORY OEM SERVICE PROCEDURE
Method 1 (No Tool)
- Sit in the vehicle driver's seat.
- Close all the vehicle doors.
- Turn the ignition switch to the run position.
- Press and hold the door lock switch to the unlock position.
- Press the transmitter unlock button. The chime will bong 1-4 times, equal to the current customization mode, to indicate which mode the vehicle is in. Each additional time the transmitter unlock button is pressed, the mode number will advance. A transition past mode four will repeat starting again at mode one.
- Release the door lock switch from the unlock position when the desired mode has been indicated by the chimes. See REMOTE LOCK/UNLOCK VERIFICATION CUSTOMIZATIONĀ table.
- Turn the ignition switch to the off position.
NOTE:
GM Tech 2Ā® scan tool or equivalent scan tool may be used to program Remote Unlock Verification. Follow screen prompts and instructions.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- ⢠You smell fuel, burning insulation, or see smoke.
- ⢠Brakes feel soft, pull hard to one side, or make grinding noises.
- ⢠The engine overheats, stalls repeatedly, or misfires under load.
- ⢠You are missing required tools, torque specs, or safe lifting equipment.
- ⢠You are not confident in the next step or safety outcome.
