Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Buick Century CustomFACTORY OEM SERVICE PROCEDURE
Method 2 (Scan Tool)
The following procedure describes how to customize the remote unlock verification feature using the Tech 2®. This procedure may also be accomplished by using an equivalent scan tool.
- Connect the scan tool to an applicable power source and the Data Link Connector (DLC).
- Turn the ignition switch to the on position.
- At the application menu screen, select the F5 (personalization).
- At the personalization main menu screen, select the F0 (set option).
- At the set option main menu screen, select the F2 (verify unlock mode).
- After reading the setting options screen, select done.
- At the set options screen, use the up and down arrow buttons to move the high lighter to the desired option (mode).
- Select the active option, then select the save option.
- Press the exit repeatedly until the application menu screen is viewed.
- Disconnect the scan tool from the accessory power port and the vehicle DLC.
- Validate that the option (mode) selected was activated by operating that system.
REMOTE LOCK/UNLOCK VERIFICATION CUSTOMIZATION
| Mode | Verification |
|---|---|
| 1 | Disabled |
| 2 | Horn Only |
| 3 | Headlights Only |
| 4 | Horn & Headlights |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
