Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC B2805: RFA Programming/Diagnostic Mode Message Not Received: Description
When any button on keyless entry transmitter is pressed, a radio frequency signal is sent to Remote Control Door Lock Receiver (RCDLR). RCDLR then decides which message to send the BCM (according to which button was pressed), which will allow BCM to operate door lock actuators, courtesy lights or remote alarm.
BCM can enable transmitter programming/diagnostic mode. BCM will detect and prevent any message collisions on Remote Function Actuator (RFA) link. BCM also receives programming signals from RCDLR when attempting to enable transmitter programming/diagnostic mode.
DTC B2805 will set when BCM expects to receive a program signal from RCDLR, and it does not after 2 unsuccessful tries. No driver warning message will be displayed. RCDLR will not enter transmitter programming/diagnostic mode.
Under all conditions, ignition switch must be cycled from LOCK/OFF to RUN position for current DTC B2805 to change to a history code. If conditions for malfunction no longer exist, history DTC will clear after 100 consecutive ignition cycles. DTC B2805 will also clear when scan tool is used to clear codes.
- TESTS W/CODES - Century
- TESTS W/CODES - Regal
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
