1996 Buick Roadmaster BaseFACTORY OEM SERVICE PROCEDURE

Remote Control Door Lock Receiver/Transmitter Will Not

PROGRAM

  1. Front probe keyless programming connector with voltmeter between terminal "B" (Black/White wire) and ground. If 6-7 volts are present, program using a known-good transmitter. If Remote Control Door Lock Receiver (RCDLR) does not program, replace RCDLR.
  2. If zero volts are present, check for open or short to ground in Black/White wire or poor connection at RCDLR connector C1 terminal "H" (Black/White wire). If connection and wire are okay, replace RCDLR.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.