Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Buick Century CustomFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS
| Component | Component Location |
|---|---|
| Automatic Door Unlock Module | Behind left side of dash, near heater duct. |
| Cruise Control Module | Front of left shock tower. See Figure . |
| Daytime Running Lamps (DRL) Module | Behind left side of dash. |
| Diagnostic Energy Reserve Module (DERM) | Behind left side of dash, right of steering column. |
| EBCM Independent Lamp Driver Module | Under left side dash, left of steering column. |
| Electronic Brake Control Module | Behind right side of dash. |
| Ignition Control Module (2.2L VIN 4) | Left rear of engine, above transaxle. See Figure . |
| Ignition Control Module (3.1L VIN M) | Top right side of engine. See Figure . |
| Power Window Control Module | Behind right side of dash. |
| Powertrain Control Module (PCM) (2.2L VIN 4) | Behind right side of dash. See Figure . |
| Powertrain Control Module (PCM) (3.1L VIN M) | Behind right side of dash. See Figure . |
| Remote Control Door Lock Receiver | Forward left rear wheelwell. |
| Seat Belt/Ignition Key/Lamps & Turn Signal Alarm (Buick) | Behind dash, left of steering column. |
| Seat Belt/Ignition Key/Lamps & Turn Signal Alarm (Oldsmobile) | Behind dash, right of glove box. |
| Windshield Wiper Motor | On left side of firewall. |
| Window Wiper Pump | Top center of tailgate. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
