Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Buick Roadmaster LimitedFACTORY OEM SERVICE PROCEDURE
Code 37, TCC Brake Switch Error: Notes
PCM monitors activity of the normally-closed brake switch. Switch opens when brake pedal is applied.
NOTE:
Test numbers refer to numbers on diagnostic chart.
- Checks for voltage at brake switch.
- Simulates brake switch closed or brakes off.
- Checks TCC brake switch circuit between PCM and switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
