1995 Buick Roadmaster BaseFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Switches

SWITCHES LOCATION

Component Location
A/C Cycling Switch Mounted on A/C accumulator. See Figure.
Backup Light/Transmission Position Switch On base of steering column.
Brake Pressure Switch Below master cylinder, on brake combination valve.
Engine Oil Pressure Gauge Sensor & Fuel Pump Switch On top rear of engine. See Figure.
Idle Speed Control Power Steering Pressure (PSP) Switch Near power steering pump, in pressure line. See Figure.
Park/Neutral Switch Near steering column base.
Parking Brake Switch Attached to top of parking brake assembly.
Seat Belt Switch Part of driver's seat belt assembly.
Stoplamp/Cruise Release Switch On brake pedal support bracket. See Figure.
Tailgate Ajar Switch Inside lower right corner of tailgate assembly.
TCC/Cruise Release Switch On brake pedal support bracket.
TCC Temperature Switch In transmission cooler pipe, near cooler.
Washer Fluid Level Switch In windshield washer reservoir, on left front fender.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.