Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Buick Roadmaster BaseFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Grounds
GROUNDS LOCATION
| Component | Location |
|---|---|
| G100 | In engine compartment, at front of right cylinder head. |
| G101 | At right front fender, near battery. |
| G102 | Behind left headlight support. |
| G104 | In engine compartment, at front of left cylinder head. |
| G106 | At right headlight support. |
| G200 | At base of left "A" pillar. |
| G201 | At base of left "A" pillar. |
| G202 | At base of right "A" pillar. |
| G300 (Sedan) | In trunk, at left rear wheelwell. |
| G300 (Wagon) | Near center of left "D" pillar. |
| G400 | Near center of right "D" pillar. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.