1995 Buick Roadmaster BaseFACTORY OEM SERVICE PROCEDURE

Anti-Lock Brake System: Diagnosis: Notes

NOTE: When using Tech 1 for diagnostics, ABS system is disabled by EBCM. ANTI - LOCK indicator will come on indicating only normal power assisted braking is available. After diagnostics have been completed using Tech 1, disconnect Tech 1 from DLC connector and turn ignition off for a least 10 seconds before road testing vehicle. This procedure is done to reset EBCM.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.