Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Buick Regal LimitedFACTORY OEM SERVICE PROCEDURE
Fuel Injector(s)
Disconnect fuel injector harness connector. Measure resistance across injector terminals at each injector. Resistance should be as specified. See INJECTOR RESISTANCE SPECIFICATIONS .
INJECTOR RESISTANCE SPECIFICATIONS (1)
| Application | Ohms | ||||||
|---|---|---|---|---|---|---|---|
| 3.8L (2) | |||||||
| VIN L | |||||||
| With Bosch Injector | 14.3-14.7 | ||||||
| Without Bosch Injector | 11.8-12.6 | ||||||
| VIN I | 14.3-14.7 | ||||||
|
|||||||
NOTE:
If injectors are dirty, they should be cleaned using approved injector cleaning procedure before performing INJECTOR BALANCE TEST.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.