SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1995LESABRE V6-3.8L VIN KREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMRELAYS AND MODULES - IGNITION SYSTEMIGNITION CONTROL MODULESERVICE AND REPAIR
1995 Buick LeSabre V6-3.8L VIN K

Ignition Control Module: Service and Repair

1995 Buick LeSabre V6-3.8L VIN KSECTION Service and Repair

Ignition Control Module And Coil Assembly:




Ignition Coils And Ignition Control Module:






REMOVE OR DISCONNECT
1. Disconnect 14 way connector at ignition control module.
2. Remove spark plug wires from coil assemblies.
3. Remove 6 screws securing coil assemblies to ignition control module.
4. Disconnect coils from ignition control module.
5. Remove nuts and washers securing ignition control module assembly to bracket.
6. Remove ignition control module.


INSTALL OR CONNECT
1. Install coils to ignition control module.
2. Install and tighten 6 screws, Torque to 4-5 Nm (40 lb.in).
3. Install and tighten nuts and washers securing assembly to bracket. Torque to 8 Nm (70 lb.in).
4. Connect spark plugs wires.
5. Connect 14 way connector to module.



RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.