Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Buick Century CustomFACTORY OEM SERVICE PROCEDURE
Brake Control Assembly
- Clean master cylinder reservoir cover and surrounding area. Remove reservoir cover. Ensure reservoir is full. Attach Bleeder Adapter (J-35589) to reservoir. Attach bleeding equipment, and pressurize system to 10 psi (.7 kg/cm2 ) for 30 seconds to ensure there are no leaks.
- Slowly increase pressure to 35 psi (2.5 kg/cm2 ). Attach a clear hose to rear bleeder valve, and submerge other end of hose in clean container. Slowly open brake control assembly rear bleeder. Allow fluid to flow until no air bubbles are seen in hose. Close valve, and repeat procedure for front bleeder valve.
- To bleed unit at brake pipe connections, position shop towel below brake pipes. Using flare nut wrench, slightly open front upper brake pipe fitting at brake control assembly. Allow air to escape, and then tighten fitting.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
