1995 Buick Century CustomFACTORY OEM SERVICE PROCEDURE

Brake Control Assembly

Clean master cylinder reservoir cover and surrounding area. Remove reservoir cover. Ensure reservoir is full. Attach a clear hose to rear bleeder valve, and submerge other end of hose in clean container. Slowly open rear bleeder. Depress brake pedal until fluid begins to flow. Close valve, and release brake pedal. Repeat procedure for front bleeder valve.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.