1995 Buick Century CustomFACTORY OEM SERVICE PROCEDURE

Transmitter Programming

NOTE: Following procedure must be performed when replacing RKE module or either transmitter.

Turn ignition switch to OFF position (all power door locks will lock and unlock). Use a fused jumper wire and jump program connector to ground. See Fig 1 . Press any button on one transmitter. Door locks, fuel door and trunk lid release should activate in approximately 2 seconds. First transmitter is now programmed. Repeat this step using other transmitter. If only one transmitter is being used, disconnect jumper wire from DLC.

Fig 1: Locating Keyless Programming Connector
G94G31902Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.