1995 Buick Century CustomFACTORY OEM SERVICE PROCEDURE

Keyless Entry System: (Sedan)

Set parking brake. Place transmission in Drive. Backprobe with test light between keyless entry receiver connector Light Blue wire and ground. If test light does not light, replace keyless entry receiver. If test light lights, check wiring for a short to voltage. If circuit is okay, replace transaxle position switch (4-speed) or park/neutral switch (3-speed).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.