Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Buick Roadmaster BaseFACTORY OEM SERVICE PROCEDURE
A-2, Mil On Steady Or Won't Flash Code 12
- Start engine. Check MIL. If MIL is not flashing, go to next step. If MIL is flashing, turn ignition off. Disconnect PCM connector "D". Using test light connected to battery voltage, probe DLC test terminal "B". See Figure . If test light illuminated, output/field service enable circuit (12-pin DLC terminal "B") is shorted to ground. If test light did not illuminate, replace faulty PCM.
- Connect DVOM between ground and DLC output/field service enable terminal (12-pin DLC terminal "B"). DVOM should read 5 volts. If reading is as specified, check for faulty PCM connection or faulty PCM. If reading is not as specified, go to next step.
- Turn ignition off. Disconnect PCM connector"D". Using jumper wire, ground DLC test terminal "B". With test light connected to battery positive, probe PCM harness connector terminal D20 (White/Black wire). Test light should illuminate. If test light illuminated, check for faulty PCM connection or faulty PCM. If test light did not illuminate, DLC test terminal "B" circuit is open.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
