1994 Buick LeSabre CustomFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS (3.8L)

Application Ft. Lbs. (N.m)
Fuel Inlet & Return Line Nuts (Non-Supercharged, VIN L) 13 (17)
Fuel Rail Retaining Bolts (Supercharged, VIN 1) 22 (30)
Throttle Body Bolts 11 (15)
Harmonic Balancer (1) 110 (149)
Ignition Module/Coil Pack-To-Bracket Nuts 14-28 (20-40)
Oxygen Sensor 30 (41)
Supercharger-To-Manifold Bolt 19 (26)
INCH Lbs. (N.m)Β 
Fuel Pressure Regulator Screws (Non-Supercharged, VIN L) 89 (10)
Fuel Rail Retaining Bolts (Non-Supercharged, VIN L) 106 (12)
Idle Air Control (IAC) Valve Screw 26 (3.0)
Throttle Position Sensor Screw 18 (2.0)
Camshaft Position Sensor Bolt 35-53 (4.0-6.0)
Ignition Coil-To-Module Screws 40 (4.5)
(1) Plus an additional 76 degrees.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.