Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code P0117, Coolant Temp Sensor Low Temp Indicated: Notes
ECT sensor uses a thermistor to control signal voltage to PCM. PCM applies and monitors a 5 volts to ECT sensor. When engine coolant is cold, sensor (thermistor) resistance is high and PCM will sense a high signal voltage. As engine coolant warms up, sensor resistance becomes less and PCM voltage drops. With Code P0117 set, PCM will turn cooling fans on and use a default engine coolant temperature value based on run time. PCM will illuminate Malfunction Indicator Light (MIL).
- Code 14 reference applies to 5.7L only. This step determines if conditions necessary to set Code P0117 exist.
- Determines if circuit is shorted to ground.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.