Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Buick ReattaFACTORY OEM SERVICE PROCEDURE
EGR Vacuum Solenoid
- Disconnect electrical connector at solenoid. Turn ignition on. Using a test light, ensure voltage is present at connector. Turn ignition off. Using an ohmmeter, check resistance across solenoid terminals. Resistance should be at least 20 ohms, but not infinity.
- Disconnect vacuum source hose at solenoid. Using a vacuum gauge connected to source hose, check that a minimum of 10 in. Hg. vacuum is present with engine running. For further testing of EGR vacuum solenoid, see appropriate C-7 CHART in the COMPUTERIZED ENGINE CONTROLS section.
CAUTION:
If EGR valve is hot, it may be necessary to wear gloves to avoid burning fingers.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
