Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Buick ReattaFACTORY OEM SERVICE PROCEDURE
Chart C5 - Electronic Spark Control (ESC): Notes
NOTE:
Test numbers refer to test numbers on diagnostic chart.
- With engine idling, there should not be a knock signal present.
- Tapping on the engine lift hook bracket should simulate a knock signal to determine if the sensor is capable of detecting detonation. If no knock is detected, knock on engine block closer to sensor.
- If engine has an internal problem which is creating knock, sensor may be responding to this internal failure.
- This step determines if the sensor is faulty or if the ESC portion of the MEM-CAL is faulty. Be sure MEM-CAL is properly installed.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
