Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1988SKYHAWK BASE, 4D WAGON, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSFLUIDS
1988 Buick Skyhawk Base, 4D Wagon, Automatic
Quick Lookups: Fluids
1988 Buick Skyhawk Base, 4D Wagon, AutomaticSECTION Fluids
| FLUID CAPACITIES | |||||||
|---|---|---|---|---|---|---|---|
| Fluid Type | Application | Standard | Metric | Fluid Spec | Note | S/H | |
| Automatic Transmission Fluid | Trans Mfr CD 125C/MD9 | 6.00 QTS. | 5.67 L | Automatic Transmission Fluid DEXRON VI | Refer to TSB No. 04-07-30-037C, Date of Issue: April 11, 2007. | S | |
| Brake Fluid | N/A | N/A | DOT 3 Brake Fluid | S | |||
| Clutch Fluid | N/A | N/A | DOT 3 Brake Fluid | S | |||
| Engine Coolant | w/Air Cond | 8.00 QTS. | 7.57 L | 50/50 mixture of Ethylene Glycol Base Antifreeze and water | GM Specification 1825-M. | S | |
| Engine Coolant | w/Heater | 8.00 QTS. | 7.57 L | 50/50 mixture of Ethylene Glycol Base Antifreeze and water | GM Specification 1825-M. | S | |
| Engine Oil | 2.0L Eng | 4.00 QTS. | 3.78 L | SAE 5W-30 (Preferred) (Below -20Deg.F to Above 100Deg.F), 10W-30 (0Deg.F to Above 100Deg.F), 30 (40Deg.F to Above 100Deg.F) | S | ||
| Power Steering Fluid | N/A | N/A | GM Power Steering Fluid | GM Part No. 1050017. | S | ||
| Windshield Washer Fluid | N/A | N/A | Optikleen Windshield Washer Fluid | Follow the Manufacturer's Instructions for the mixture ratio. | S | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.