Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1988 Buick Regal CustomFACTORY OEM SERVICE PROCEDURE
Est Performance Check
- The ECM will set timing at a specified value when diagnostic test terminal of the ALDL connector is grounded. To check the EST operation, perform the following steps:
- Start and run engine at 1500 RPM with the ALDL diagnostic test terminal NOT grounded. Ground test terminal. When ALDL test terminal is grounded there should be a noticeable change in engine RPM. When a fault in the EST system takes place, a code 42 should be set.
- If code 42 is set, use appropriate chart for diagnosis. If symptom is engine miss and the direct ignition system is suspect, use CHART C-4D DIS MISFIRE in the 2.8L VINS [S,9] PFI CEC TESTS W/CODES article in the ENGINE PERFORMANCE section for proper diagnosis.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.