Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Buick Electra BaseFACTORY OEM SERVICE PROCEDURE
Volume Test: Mechanical
- Check fuel supply to verify sufficient gasoline in the tank. Disconnect ignition wire from distributor so that engine will not start.
- Separate fuel line at carburetor inlet fitting. Install a piece of fuel resistant hose over the end of fuel line. Place end of hose into a gasoline container.
- Crank engine to activate fuel pump. The amount of fuel pumped will vary according to each manufacturer. The average pump output should be about one pint in 30 seconds.
- If little or no gasoline flows from hose, check fuel lines or gasoline tank filter for restrictions or leaks. If lines and filter are clear, pump is defective and must be replaced.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.