Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1985 Buick Skylark Custom, 2.8 W, StandardFACTORY OEM SERVICE PROCEDURE
Choke Unloader
NOTE:
This adjustment is performed using the choke valve angle gauge. See procedure at beginning of ADJUSTMENTS.
- Attach rubber band to intermediate choke lever. Open throttle to allow choke valve to close. See Fig 1 .
- Set up angle gauge and set to specified angle. Hold throttle lever in wide open position.
- Push on choke shaft lever to open choke valve and to make contact with closing tang. To adjust, bend tang on throttle lever until bubble is centered.
- Remove gauge and reinstall choke cover and coil assembly if previously removed. Install service rivet and retainer kit.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.