1980 Buick Skyhawk Base, Automatic TransFACTORY OEM SERVICE PROCEDURE

Catalytic Converter

Proper emission control is accomplished with the special catalytic converter used with this system. It is a 3-way converter; that is, it converts all three major pollutants (HC, CO and NOx). In order for this catalytic converter to be effective, precise control of the oxygen content of gases entering the converter is necessary, thus the need for the oxygen sensor, ECM and special carburetor.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.