Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1979REGAL BASE, 3.2L ENG VIN CLABOR TIMESENGINE PERFORMANCEIGNITION SYSTEMSDISTRIBUTOR ASSEMBLYREMOVE & REPLACE
1979 Buick Regal Base, 3.2L Eng VIN C
Distributor Assembly: Remove & Replace
1979 Buick Regal Base, 3.2L Eng VIN CSECTION Remove & Replace
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| V6,Normally Aspirated | Includes: Check and adjust Ignition Timing. | 0.8 | C | |
| Additional Procedure: DISTRIBUTOR ASSEMBLY: Remove & Replace: | ||||
| w/Aux Vacuum Pump add | 0.2 | C | ||
| Where Air Pump interferes add | 0.3 | C | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.