Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 BMW X4 M BaseFACTORY OEM SERVICE PROCEDURE
Engine -- Tightening Torques (F98)
Select a section or procedure below to view factory instructions:
1100 Engine, General1111 Engine Block1112 Cylinder Head1113 Engine Oil Pan1114 Rear Timing Case Cover1121 Crankshaft1122 Flywheel1123 Engine Vibration Damper1124 Connecting Rod Bearing Caps1128 Idler Pulley1130 Special Tool For Camshaft Alignment1131 Camshafts1136 Variable Camshaft Timing Control System (VANOS)1137 Variable Camshaft Lift Control System (VALVETRONIC)1141 Engine Oil Pump1142 Engine Oil Filter, Engine Oil Lines1151 Water Pump1152 Radiator Fan1153 Thermostat, Coolant Lines1161 Intake Plenum, Charge Air Cooler, Intake Manifold1165 Turbocharger
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.