Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2021I3 RANGE EXTENDERREPAIR AND DIAGNOSISGENERAL INFORMATIONOEM GENERAL INFORMATIONGENERAL ORPHAN DATAFRONT PANEL
2021 BMW i3 Range Extender
Front panel
2021 BMW i3 Range ExtenderSECTION Front panel
51 64 FRONT PANEL - TIGHTENING TORQUES SPECIFICATIONS
| Type | Thread | Tightening specifications | Dimension | |||
|---|---|---|---|---|---|---|
| 1AZ Module bracket, side panel to front panel | I01 | 3.5 Nm | ||||
| 2AZ Front panel to holder, rear | I01 | M8x80 | Replace screw. | 28 Nm | ||
| 3AZ Front panel to support | I01 | 19 Nm | ||||
| 4AZ Headlamp support bracket on front panel | I01 | 8 Nm | ||||
| 5AZ storage box | I01 | 3 Nm | ||||
| 6AZ Lock support to front panel | I01 | 7.6 Nm | ||||
| 7AZ Holder, expansion tank to front panel | I01 | M6x20 | 8 Nm | |||
| 8AZ Air duct to deformation element | I01 | 4 Nm | ||||
| 9AZ Holder, headlight to front panel | I01 | 8 Nm | ||||
| 10AZ Stand, radiator, top to strut | I12 / I15 | 8 Nm | ||||
| 11AZ Cross connection, top to support Front panel | I12 / I15 | 8 Nm | ||||
| 12AZ Support, front panel to console | I12 / I15 | 8 Nm | ||||
| 13AZ Console, front panel console to engine mount | I12 / I15 | 8 Nm | ||||
| 14AZ Air routing at the front on the cross-member | I12 | 5 Nm | ||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.