SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2021X6 M COMPETITIONREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 36 (COMPUTER RELEARN PROCEDURES)INTRODUCTIONALL MODELS
2021 BMW X6 M Competition

All Models

2021 BMW X6 M CompetitionSECTION All Models
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2003 BMW Z8, 2003 BMW Z4, 2003 BMW X5, 2003 BMW M5, and 2003 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When DME control unit is disconnected or its power supply interrupted, all stored intermittent DTCs as well as substitute values are cleared/lost. Current hard DTCs cannot be cleared.

After disconnecting battery or replacing DME control unit, drive vehicle to enable DME control unit to relearn driveability. Inform your customer that they may experience driveability different from what they are accustomed to until DME control unit completes relearn function. System Readiness Test (SRT) information was not available from manufacturer.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.