Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 BMW X2 sDrive28iFACTORY OEM SERVICE PROCEDURE
Engine -- Tightening Torques X2 (F39)
Select a section or procedure below to view factory instructions:
1100 Engine (X2 2018-2023)1111 Engine Block (X2 2018-2023)1112 CYLINDER HEAD WITH LID (X2 sDrive 28i 2018-2023, X2 xDrive 28i 2018-2023)1112 CYLINDER HEAD WITH LID (X2 M35i 2019-2022)1113 Oil Pan (X2 2018-2023)1114 Housing Cover (X2 2018-2023)1116 Component Carrier (X2 2018-2023)1122 Flywheel (X2 2018-2023)1123 Vibration Damper (X2 2018-2023)1124 Connecting Rod With Bearing (X2 2018-2023)1127 Counterbalance Shafts (X2 2018-2023)1128 V Belt With Belt TENSIONER And Idler Pulley (X2 2018-2023)1130 Camshaft Alignment Tool (X2 2018-2023)1131 Camshaft (X2 2018-2023)1136 VARIABLE CAMSHAFT TIMING CONTROL (VANOS) (X2 sDrive 28i 2018-2023, X2 xDrive 28i 2018-2023)1136 VARIABLE CAMSHAFT TIMING CONTROL (VANOS) (X2 M35i 2019-2022)1137 Variable Valve Lift Control System (VALVETRONIC) (X2 2018-2023)1141 Oil Pump (X2 2018-2023)1142 OIL FILTER AND LINES (X2 sDrive 28i 2018-2023, X2 xDrive 28i 2018-2023)1142 OIL FILTER AND LINES (X2 M35i 2019-2022)1151 WATER PUMP (X2 sDrive 28i 2018-2023, X2 xDrive 28i 2018-2023)1151 WATER PUMP (X2 M35i 2019-2022)1153 Thermostat And Coolant Lines (X2 2018-2023)1161 INTAKE MANIFOLD (X2 sDrive 28i 2018-2023, X2 xDrive 28i 2018-2023)1161 INTAKE MANIFOLD (X2 M35i 2019-2022)1165 Turbocharger (X2 2018-2023)1178 Co Adjustment, Oxygen Sensor (X2 2018-2023)1121 Crankshaft With Bearing (X2 2018-2023)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
