2020 BMW i3 BaseFACTORY OEM SERVICE PROCEDURE

1161 Intake Plenum

11 61 INTAKE PLENUM - TIGHTENING TORQUE SPECIFICATIONS

  Type Thread Tightening specifications Dimension
1AZ Intake plenum to intake manifold. W20 M6x25   10 Nm
2AZ Intake manifold to cylinder head. W20 M6   10 Nm
3AZ Intake plenum to holder W20 M6x28   10 Nm
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.