Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 BMW M6 Standard TransFACTORY OEM SERVICE PROCEDURE
12 00... Instructions on component testing
NOTE:
- During all inspections and work on engine electrics and electronics, always observe safety regulations and accident prevention specifications.
- Always disconnect connectors of control units or components before checking electric wires.
Testing Aids:
- Schematics, refer to BMW Diagnosis Information System (DIS)
- Use appropriate test lines, adapters, terminals and test tips, refer to BMW Diagnosis Information System (DIS)
- The inspection values for component testing are located in the BMW Diagnosis Information System (DIS)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.