2017 BMW i3 BaseFACTORY OEM SERVICE PROCEDURE

11 00 599 Removing/installing engine from drive unit

WARNING: High-voltage system - danger to life 
Compliance with the following points is mandatory before beginning work:

Necessary preliminary tasks: 

REMOVAL: 

Fig 1: Identifying Coolant Hose, Retaining Clip, Clamps And Sound Insulation
G11144294Courtesy of BMW OF NORTH AMERICA, INC.

Unclip and remove coolant hose (1) from retaining clip (2).

Lift clamps (3) off of sound insulation (4).

Feed out and remove sound insulation (4).

Unlock and disconnect coolant hose (5).

Fig 2: Identifying Screws And Nut
G11144295Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Release nut (2) on catalytic converter.

Release screws (3) from catalytic converter holder.

Feed out catalytic converter holder.

Release screws (1).

Fig 3: Identifying Screws
G11144296Courtesy of BMW OF NORTH AMERICA, INC.

Overview of table lift: 

  1. Fixed table lift side
  2. Moving table lift side
  3. Fig 4: Identifying Table Lift
    G06889535Courtesy of BMW OF NORTH AMERICA, INC.
NOTE: Pull apart slightly for better accessibility of electrical machine with electrical machine electronics of range extender.

Unlock and disconnect coolant hose (1).

For alternating current rapid charging equipment (SA4U8): Detach coolant hose (2).

For alternating current rapid charging equipment (SA4U8): Feed out coolant hose (3).

Fig 5: Detaching Coolant Hose
G11144298Courtesy of BMW OF NORTH AMERICA, INC.

Move table lift plate (B) in direction of arrow.

Fig 6: Moving Table Lift Plate
G11144299Courtesy of BMW OF NORTH AMERICA, INC.

INSTALLATION: 

Move table lift plate (B) in direction of arrow.

Fig 7: Moving Table Lift Plate
G11144300Courtesy of BMW OF NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.