Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 BMW M3 Standard TransFACTORY OEM SERVICE PROCEDURE
Fuel System - Repair (F80)
- 13 31 Fuel Pressure Test
- 13 51 Fuel Pump
- 13 53 Fuel Injectors, Fuel Pressure Sensors, And Fuel Lines
- 13 54 Throttle Body
- 13 62 Fuel System Sensors
- 13 53 594 Replacing fuel low-pressure sensor (S55)
- 13 53 596 Replacing high pressure fuel sensor (S55)
- 13 62 531 Replacing coolant temperature sensor (S55)
- 13 62 560 Removing and installing/replacing left or right hot film air mass meter (S55)
- 13 62 582 Removing and installing/replacing oil temperature sensor (S55)
- 13 62 596 Replacing differential pressure sensor for gasoline particulate filter (after vehicle diagnosis), cylinders 1-3
- 13 62 597 Replacing differential pressure sensor for gasoline particulate filter (after vehicle diagnosis), cylinders 4-6
- 13 62 598 Replacing both differential pressure sensors for gasoline particulate filter (after vehicle diagnosis)
- 13 62 630 Replacing pulse sensor for high pressure pump drive (S55)
- 13 71 Intake Silencer
- 13 71 010 Removing and installing/replacing intake silencer housing, left (S55)
- 13 71 020 Removing and installing/replacing intake silencer housing (S55)
- 13 71 040 Removing and installing/replacing front intake air duct (S55)
- 13 71 042 Removing top rear intake air duct (S55)
- 13 71 043 Removing bottom rear intake air duct (S55)
- 13 72 Engine Air Filter
- 13 90 Fuel Tank Vent Valve
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.