2017 BMW M3 Standard TransFACTORY OEM SERVICE PROCEDURE

1122 Flywheel

11 22 FLYWHEEL - TIGHTENING TORQUE SPECIFICATION

Β  Type Thread Tightening specifications Dimension
1AZ Flywheel to crankshaft (twin-clutch gearbox) S55 M12x 19 Replace screws
  1. Jointing torque
  2. Final torque
60 Nm
45Β°
2AZ DM flywheel to crankshaft (manual transmission) S55 M12x25 Replace screw
  1. Jointing torque
  2. Final torque
60 Nm
45Β°
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.