Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 BMW 340i xDrive Automatic TransFACTORY OEM SERVICE PROCEDURE
Engine Electrical System - Repair (F30, 6-CYL AWD)
- Engine Electrical System
- Ignition Wire, Spark Plugs
- Ignition Coil
- Electronic Switching Or Control Units
- 12 14 521 Replace crankshaft sensor (after vehicle diagnosis)
- 12 14 523 Replacing the camshaft sensor of the intake camshaft (after vehicle diagnosis)
- 12 14 524 Replacing the camshaft sensor of the exhaust camshaft (after vehicle diagnosis)
- 12 14 550 Replacing the control unit of the Digital Motor Electronics (After vehicle diagnosis)
- 12 14 602 Replacing knock sensor (after vehicle diagnosis) (cylinders 1+2)
- 12 14 604 Replacing knock sensor (after vehicle diagnosis) (cylinders 3+4)
- 12 14 700 Coding the control unit (DME/DDE)
- 12 14 705 Programming the control unit (DME/DDE)
- Alternator With Drive And Attachment
- Starter With Attachment
- Starter Line
- Engine Wiring Harness
- 12 51 210 Replacing the wiring harness section for injectors and ignition coils
- 12 51 215 Replace wiring harness section for Valvetronic servomotor
- 12 51 235 Remove and install/replace Module 1, sensor system engine wiring
- 12 51 240 Remove and install/replace Module 2, sensor system engine wiring
- 12 51 245 Removing and installing/replacing transmission module engine wiring
- Oil Pressure, Oil Temp, Oil Level Check
- Switch And Relay
- E-Box
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
